How do I test a GR3 control panel?

GR3 test procedure:

1. 1. 1. Switch off the power to the unit
      2. Change the position of the sw2 dip switch # 4 to on.
      3. Change the position of the display dip switch 1 to 8 as follows on off on off on off on off.
      4. Turn the power supply back on.
      5. The two led’s beside the dip switches should indicate a
      6. Yellow flashing heart beat gr3 board is powered on
      7. Red flash communication error between gr3 and gro3 display.  On a start up for a few seconds

Answer the following questions after power up by using the up and down arrows for yes and no

1. 1. 1. Reset alarms recorded
      2. Reset default parameters
      3. Hardware test